Tenda V300 - WAN Service Management

25
And then refer to To Set up WAN Service for Ethernet Interface to configure the WAN service for internet access.
--End
4.2 WAN Service
Choose Advanced > Advanced Setup > WAN Service to enter the WAN Service page.
4.2.1 To Set up WAN Service for PTM Interface
Log in to the web UI, choose Advanced > Advanced Setup > WAN Service to enter the following page.
Step 1 Click Add.
Step 2 Select the interface you create in Layer2 Interface, interface ptm0/(0_1_1) here.
Step 3 Click Next.
Step 4 Select a WAN service type according to the instructions in the table below. Here take PPPoE as an
example.