Section 3 - Maintenance Inspections November 2008
MAINTENANCE INSPECTIONS
Document 57.0009.0427
GTH-4017EX GTH-4514EX GTH-4013EX
4
TABLE B
Within the first 50 working hours:
B-1 Check the general efficency of the machine.
Every 50 working hours or weekly:
B-2 Check the tension of the alternator belt.
B-3 Check the tyre inflation.
B-4 Check the tightening of the wheel nuts.
B-5 Check the tightening of the cardan shaft screws.
B-6 Clean the fins of radiator.
TABLE C
Within the first 100 working hours
C-1 Change the oil in the differential gears, in the four wheel reduction gears and in the power divider.
Every 250 working hours or monthly:
C-2 Change the engine oil and relevant filter
C-3 Check the oil level in the front and rear differential gears.
C-4 Check the oil level in the four wheel reduction gears.
C-5 Check the main filtering element of the engine air filter. Replace, if necessary.
C-6 Check the clamping of the cableheads to the battery terminals.
C-7 Check the air suction hose between engine and filter. Replace, if necessary.
C-8 Check the cylinder chromium-plated rods.
C-9 Check the hydraulic lines are not worn because of rubbing against the frame or other mechanical
components.
C-10 Check the electric cables do not rub against the frame or other mechanical components.
C-11 Check the wear of the sliding pads of the boom sections.
C-12 Adjust the play of the sliding pads of the boom sections.
C-13 Remove any grease from the boom, then re-grease the sliding parts of the boom sections.
C-14 Check the level of the battery electrolyte.
C-15 Check the efficiency of the block valves.
To Next Page
Loading...
