area is restricted to the over side and over rear areas as shown on the Crane Working
Positions diagram. Use the 360° load rating in the overside work areas.
Crane Working Positions with Outriggers Extended: Areas measured in a circular arc about
the centerline of rotation as shown in the diagram below.
1.
Boom over front working area
2.
Boom over side working area
3. Boom over rear working area
NOTE: Ballooned items no. 1, no. 2 & no. 3 determine the limits of WORKING
POSITIONS which correspond to those shown on the Crane Capacity Charts.
197P/N 12261-683 REVISED: January 2015
To Next Page
