1. Apply multi-purpose grease along the entire length of the section to the outer 5"
of both sides of the top plate of Section 3. This area can be accessed through the
holes in the #3 section.
2.
Apply a fist sized portion of grease in the center of the bottom plate on the inside
through each of the holes in the boom on the path where the cylinder slides.
3.
No greasing of the 4th section (tip section) is required. Cycle boom in and out a
few times to distribute the grease evenly between wear pads before starting
normal crane operation.
329P/N 12261-683 REVISED: January 2015
To Next Page
Loading...
