Texas Instruments MSP430

168
if(n > 2)
{
n = 0;
}
P1OUT &= ~BIT6;
}
switch(n)
{
case 1:
{
ADC_Value = get_ADC(INCH_1);
res = get_volt(ADC_Value);
LCD_goto(0, 0);
LCD_putstr("ADC Ch01:");
LCD_goto(0, 1);
LCD_putstr("Volts/mV:");
break;
}
case 2:
{
ADC_Value = get_ADC(INCH_2);
res = get_volt(ADC_Value);
LCD_goto(0, 0);
LCD_putstr("ADC Ch02:");
LCD_goto(0, 1);
LCD_putstr("Volts/mV:");
break;
}
default:
{
ADC_Value = get_ADC(INCH_10);
res = get_temp(get_volt(ADC_Value));
LCD_goto(0, 0);
LCD_putstr("ADC Ch10:");
LCD_goto(0, 1);
LCD_putstr("TC/Deg.C:");
break;
}
}
lcd_print(12, 0, ADC_Value);
lcd_print(12, 1, res);
delay_ms(200);
};
}
void GPIO_graceInit(void)
{
/* USER CODE START (section: GPIO_graceInit_prologue) */
/* User initialization code */
/* USER CODE END (section: GPIO_graceInit_prologue) */
/* Port 1 Output Register */
P1OUT = BIT3;