Texas Instruments MSP430 - Code Example

77
Code Example
#include <msp430.h>
#include "delay.h"
#include "SW_I2C.h"
#include "PCF8574.h"
#include "lcd.h"
void Flash_graceInit(void);
void GPIO_graceInit(void);
void BCSplus_graceInit(void);
void System_graceInit(void);
void WDTplus_graceInit(void);
void lcd_print(unsigned char x_pos, unsigned char y_pos, unsigned char value);
void Flash_Erase(unsigned int address);
void Flash_Write_Char(unsigned int address, char value);
char Flash_Read_Char(unsigned int address);
void Flash_Write_Word(unsigned int address, unsigned int value);
unsigned int Flash_Read_Word(unsigned int address);
void main(void)
{
unsigned char value = 0x00;
/* Stop watchdog timer from timing out during initial start-up. */
WDTCTL = WDTPW | WDTHOLD;
/* initialize Config for the MSP430F2xx Flash Memory Controller */
Flash_graceInit();
/* initialize Config for the MSP430 GPIO */
GPIO_graceInit();
/* initialize Config for the MSP430 2xx family clock systems (BCS) */
BCSplus_graceInit();
/* initialize Config for the MSP430 System Registers */
System_graceInit();
/* initialize Config for the MSP430 WDT+ */
WDTplus_graceInit();
LCD_init();
LCD_clear_home();
LCD_goto(0, 0);
LCD_putstr("MSP430 Flash Ex.");
value = Flash_Read_Char(0x1000);
LCD_goto(0, 1);
LCD_putstr("WR: ---");
LCD_goto(9, 1);
LCD_putstr("RD:");
lcd_print(13, 1, value);
delay_ms(2000);