Texas Instruments MSP430

206
while(1)
{
ADC10CTL0 &= ~ENC;
while (ADC10CTL1 & BUSY);
ADC10CTL0 |= (ENC | ADC10SC);
LCD_goto(0, 0);
LCD_putstr("A03:");
lcd_print(12, 0, ADC_value[8]);
LCD_goto(0, 1);
LCD_putstr("A11:");
lcd_print(12, 1, ADC_value[0]);
P1OUT ^= BIT0;
delay_ms(900);
ADC10CTL0 &= ~ENC;
while (ADC10CTL1 & BUSY);
ADC10CTL0 |= (ENC | ADC10SC);
LCD_goto(0, 0);
LCD_putstr("A00:");
lcd_print(12, 0, ADC_value[11]);
LCD_goto(0, 1);
LCD_putstr("A10:");
lcd_print(12, 1, ADC_value[1]);
P1OUT ^= BIT0;
delay_ms(900);
};
}
void GPIO_graceInit(void)
{
/* USER CODE START (section: GPIO_graceInit_prologue) */
/* User initialization code */
/* USER CODE END (section: GPIO_graceInit_prologue) */
/* Port 1 Output Register */
P1OUT = 0;
/* Port 1 Direction Register */
P1DIR = BIT0;
/* Port 1 Interrupt Edge Select Register */
P1IES = 0;
/* Port 1 Interrupt Flag Register */
P1IFG = 0;
/* Port 2 Output Register */
P2OUT = 0;
/* Port 2 Port Select Register */
P2SEL &= ~(BIT6 | BIT7);
/* Port 2 Direction Register */