Performing an Experiment 9
Performing an Experiment
When performing an experiment, these basic steps are the same no
matter which type of experiment you perform.
1. Start a new document or problem.
Important! If you connect a sensor before starting the Vernier
DataQuest™ application, the software automatically opens the
Vernier DataQuest™ application.
2. Connect a sensor.
3. Modify sensor settings. (Optional, if using default settings)
4. Set the collection mode. (Optional, if using default settings)
5. Collect data.
6. Stop collecting data.
7. To save the data for future use, store the data set.
8. Save the experiment.
9. Analyze data.
10. Print data. (Optional, if you do not need a paper copy.)
Starting a Document
TI recommends starting a new document for each new experiment.
Starting a new document ensures that the Vernier DataQuest™
application is set to its default values.
Important: The handheld can only have one document open. You are
prompted to save it before creating a new document. TI also
recommends that you have only one document open so the system
assigns the sensor to the correct document.
Starting a New Document
To start a new document:
1. Click
File > New TI-Nspire Document.
Handheld: Press c, and then select New Document.
A new document opens.
2. Click
Add Vernier DataQuest.
The Vernier DataQuest™ opens.
To Next Page
Loading...
