TI-Nspire™ Lab Cradle 89
TI-Nspire™ Lab Cradle
The TI-Nspire™ Lab Cradle is a device used with TI-Nspire™ handhelds,
TI-Nspire™ software for computers, or as a stand-alone tool to collect
data.
The Lab Cradle supports all TI sensors. It also supports more than 50
analog and digital Vernier DataQuest™ sensors, including motion
detectors and photogate sensors. To see the full list of supported sensors,
go to education.ti.com/education/nspire/sensors.
Important: The TI-Nspire™ CM-C Handheld is not compatible with the
Lab Cradle and only supports the use of a single sensor at a time.
The Lab Cradle comes pre-loaded with its own operating system (OS). The
TI-Nspire™ 3.0 operating system for handheld and computer software
has been preset to recognize the Lab Cradle so you can start using it
immediately.
Note: Any TI-Nspire™ OS earlier than 3.0 will not recognize the Lab
Cradle. For more information about upgrading a handheld OS, see
Getting Started with the TI-Nspire™ CX Handheld or Getting Started
with the TI-Nspire™ Handheld.
To Next Page
Loading...
