THOMSON MEC 320 - GENSET CONTROLLER - Page 58

MEC 320 GENSET CONTROLLER
PM079 Rev 0 07/06/08 58 Thomson Technology
VDO sensor
type
Value Type
configurable
% Resistance
0 Point 1
10
20
30
40 Point 2
50 Point 3
60 Point 4
70 Point 5
80 Point 6
90 Point 7
100 Point 8
VDO usage
The VDO inputs are used as alarm inputs and can be configured in the following menus:
VDO input 104: Lubricating oil pressure – alarm settings in menus 4170/4180.
VDO input 105: Cooling water temperature – alarm settings in menus 4190/4200.
VDO input 106: Fuel level switch – alarm settings in menus 4210/4220.
Illustration of configurable inputs
Configuration
Set points
Set point 1
Set point 2
Set point 3
Set point 4
Set point 5
Set point 6
Set point 7
8 7 6 5 4 3 2 1
Value
(bar, °
C or %)
Resistance
()
Set point 8
The configurable type is configurable with 8 points.