THRUSH S2R – G10 - Rudder Control Cables Installation

THRUSH AIRCRAFT, INC – MODEL S2R-G10
AIRCRAFT MAINTENANCE MANUAL
Effective: 03/26/2010 Page 7-11
from the turnbuckles aft are free for
removal.
RUDDER CONTROL CABLES
INSTALLATION
Ref. Figure 7-6
E. Disconnect cables from adjustment
channel. The cables from the
turnbuckles forward to the pedals are
free for removal.
A. Install the cables in reverse order of the
removal procedures.
B. Check rigging per rigging instructions.
F. Remove the balance cables.
C. Assure all cables, cable guards and
turnbuckles are installed properly and
safety wired. Replace all skins removed
for access.
G. Remove rudder-aileron cable from
aileron vertical bell crank
Figure 7-6: Rudder Control System