TD80™ Level Gauging and Overfill Prevention System Product Manual
Page 132 TD80 Programming/ Rev. 2, August 4, 2015
Using the new programming cable SVRS232 to USB Converter
1. Ensure that the power supply or battery voltage is turned off. Unplug the AC power
adapter from the outlet if it is being used for programming.
2. Verify that the area is free of explosive fumes
3. Plug the AC power adapter into the SV converter OR
Ensure that the truck battery is well charged and measures at least 8VDC.
4. Connect the programming adapter according to the instructions in section 6.3.5.
Programming Steps
Run the Birdfeeder 2 software. The birdfeeder programming steps are listed below and
on the left hand side of the window as a guide.
Step 1:
Open a file for programming or the following:
1. Select the probe or transmitter type for programming
2. Select the depth and volume units
3. Enter the depth and volume information directly into the table
Step 2:
1. Click the Done button if the table in Step 1 was entered manually.
2. Convert or confirm the depth and volume units for the table
Step 3:
1. Select or confirm the correct Spill alarm level
2. Select or confirm the correct Spill alarm reset option
3. Enter or confirm the correct HH alarm level
4. Select or confirm the number of decimal places to display
Step 4:
1. Set or confirm the optional Sump and Riser distances
2. Set or confirm the optional 4-20mA offset points
Step 5:
1. Confirm all values and settings by viewing the data presented on the screen
2. Click on the Program button
3. Save the file if necessary
4. Apply power to the TD80 transmitter when prompted
5. Click on the Continue button
6. A window will appear indicating success or failure of the programming operation
To Next Page
Loading...
Need help?
General
