TD80â„¢ Level Gauging and Overfill Prevention System Product Manual
Rev. 2, August 4, 2015/ TD80 Programming Page 159
Blank Depth Chart Form
The following form can be used when creating a depth chart for a particular tank or
compartment. Enter the liquid volume (e.g.: M3, BBL’s, Gallons etc.) at each inch. This
can then be entered into the Birdfeeder software for programming the TD80 Transmitter.
Note: The maximum length of the TD80 probe is 92 inches.
Depth Units: (inches) Volume Units: (M3, Liters, BBL’s)
Figure 6-8: Blank Depth Chart Form