1-2
- Install the instrument in a place where it is not exposed to water
and / or chemicals. In case Water and / or chemicals enter into
instrument, it may cause struck by electricity or malfunction.
- Install the instrument in a place where it is fear free of adverse
influences by direct sunbeams, high temperature, high moisture,
dust, salt, sulfur contained air, which may otherwise cause the
instrument with malfunction or erroneous operation.
- Install the instrument in a stable place where it is free of
inclination, vibration and/or shocks, which may cause incorrect
measurement, tilting, or falling, possibly resulting in inflammation
or physical injury.
Sufficient care shall be taken on the following items while
operating the instrument.
- In the event the instrument causes smokes, odors, or abnormal
noises, immediately turn the power off, disconnect the power
plug from the receptacle, and then report so to your local
distributor, representative, or Tomey Corporation.
- Pay attention and carefully to the position of Patient's face and
hand or fingers ,When operating Measurement Head and Chin
rest. It may cause physical injury depend on movement of
Measurement Head and Chin rest.
- Advise the Patient not to place his hand and fingers in the under
space of the Measurement Head or below Chin rest, which may
otherwise cause his hand and fingers to be pinched and harmed.
- Do not either lean or compress the instrument, which may
otherwise cause its fall or malfunction, or personal injuries.
- Do not place or leave any liquid contained bin or container on the
instrument, which may cause struck by electricity or
malfunctions.
- Do not touch the Printer paper cutter with your fingers, which may
cut yourself.
- Before measuring the next Patient, remove the top sheet of
paper from the Chin Rest and clean the Head Rest with clean
cloth. Also, clean the Head Rest and the Chin Rest with
sterilization alcohol-soaked cloth for sterilization.
1.1 SAFETY PRECAUTIONS
To Next Page
Loading...
Need help?
General
