Tomey RC-5000 User Manual

3-16
3.4 PRINTOUT
3.4.1 Printing-out procedures
Make sure that the built-in Printer is loaded with the
paper roll. (See "5.5.1 Replacing of the Printer
Paper")
If the Printout for built-in Printer is off at the time of
setting data output, printing out cannot be made.
Set the printing out of the built-in Printer ON, by
referring to "3.8.1 Setup".
If making the following measurement after printing
out, previously measured data will automatically be
deleted and the measurement number will be
added with "1".
Since the built-in Printer of this instrument is of
thermal printing, the print made will gradually fade
as the elapse of time. Duplicate copies of the
printout of measurement data, if will be preserved
for long time.
Printing-out after measurement is performed by pressing the
PRINT button $. If Auto Print is set on, measured data will
be automatically printed out after both eyes are measured prop-
erly by set up times of measurement. But in following case,
consider to require additional measurement or going to addi-
tional measurement, do not print out automatically. As for
setting of Auto Print, see "3.8.1 Setup".
y Changed measurement mode halfway.
y Measured by measurement switch of joystick.
y Not using Auto Shot.
y Not getting set up measurement data with measurement
error.
See "3.8.1 Setup" for setting automatic printing.
Ԙ
3.4 PRINTOUT

Tomey RC-5000 Specifications

General

Brand	Tomey
Model	RC-5000
Category	Measuring Instruments
Language	English