Tomey RC-5000 User Manual

3-21
3.6 DATA MANAGEMENT WITH "TOMEY LINK"
Tomey's TOMEY Link (including the LAN adapter) is con-
veniently used for data management which corresponds to
the computer network.
If the TOMEY Link is connected to external
equipment other than the LAN Adapter (LA-100),
observe the following requirements, which may
otherwise cause struck by electricity .
- Use the serial communication cable for
connecting the TOMEY Link.
- The equipment to which the TOMEY Link is
connected shall conform with the IEC60601-1 or
the IEC950 and of which power source shall be
isolated with the isolating transformer.
Setting-up of the TOMEY Link server software and
the LAN Adapter (LA-100) to the TOMEY Link shall
be referred to the instruction manual of the TOMEY
Link. This Manual prescribes the connection
procedure of the TOMEY Link with the RC-5000
only.
No data communications can be obtained unless
entering the Patient's ID.
3.6.1 Setup
1) For setting of External communication in the Output
Setup, select TOMEY Link. (See "3.8.1 Setup".)
2) After finishing the Setup screen, the Input Patient's ID
screen will be displayed. If the connection with the
TOMEY Link is selected, this Input Patient's ID screen
is always displayed when a new measurement is started.
If you measuring Temporally without sending
Patient's information or data, press Cancel Button.
3.6 DATA MANAGEMENT WITH "TOMEY LINK"

Tomey RC-5000 Specifications

General

Brand	Tomey
Model	RC-5000
Category	Measuring Instruments
Language	English