3-7
7) When Auto Shot is ON, automatically measurement till the
number of measurement times which is set.
8) Touch an icon of other side eye (R or L), Measurement
Head moves automatically to the other side eye when fin-
ish measurement of the one side eye.
<When auto alignment is ON>
The background color of [AA] displayed in the right bottom of
the screen turns to green.
Use the Joystick to locate the target bright spot $ is in the auto
alignment ring %. When the reflected light spot of the center of
the cornea $ comes into the auto alignment ring %, alignment
for the up/down and right/left directions and focusing frontward
/rearward are automatically started. As for the setting of auto
alignment, see "3.7.1 Setup".
<When auto alignment is OFF>
The background color of [AA] displayed in the right bottom of
the screen turns to gray.
Locate the reflected light spot of the center of the cornea $
into the target ring % by using the Joystick. Move the Joystick
back and forth to make the focus indicator & smaller. When
the focus indicator & is not displayed, adjust focusing on the
target reflected light spot $ or the iris '.
<Optical Head moving area>
When Optical Head comes to close to the edge of its moving
area, a yellow bar appears at side of the screen. Adjust poison
of the patient's head and take a measurement with the bar dis-
appeared.
Ԙ
ԙ
Ԙ
ԙ
Ԛ
ԛ
(Fig.2)
(Fig.3)
3.2 PREPARATION FOR MEASUREMENT
(Fig.4)
To Next Page
Loading...
Need help?
General
