3-53
■
1) Touch the “IOP” button (1) to open the intraocular pressure correction screen
(Fig. 1). When a measurement has already been completed at this point, the
measured value is displayed in the CCT field (2).
However, if measurement points are set and two or more “CCTs” are
included in them, the average of the CCTs is displayed. When measurement
points are not set, the average of all memory numbers is displayed.
2) The input fields of the parameter 1 (3) and parameter 2 (4) for the intraocular
pressure correction formula become active when touched, and the keypad
appears. Also, when a formula selection button (5) is touched, the
parameters already set are displayed in the intraocular pressure correction
formula.
[Input range]
■ Parameter 1 : 0 - 1500
■ Parameter 2 : 0.0000 - 1.0000
3) Enter the intraocular pressure data. Touch the input field (6). The keypad
appears.
[Input range]
■ Intraocular pressure data : 1 - 60.0 (mmHg)
1.33 - 79.99 (hPa)
4) Touch the “Back” button (7) to close the intraocular pressure correction
screen (Fig. 1) and return to the previous screen.
b) Deleting part of measurement data
1) Touch a memory number button (1) to select the measurement data to be
deleted.
2) Touch the “Delete” button (2) to delete the selected measurement data, and
the average and the standard deviation of the corneal thickness are
recalculated.
3) If you have deleted data mistakenly or want to cancel the deletion, select that
data number and you will see that the “Delete” button (2) will change to the
To Next Page
Loading...
Need help?
General
