Topcon ES-65 - To Select Existing Job; When Job Is Not to be Used; Setting

19-3
19 TOP FIELD MODE
19.2.4When Job is not to be Used
Job selection can be canceled if the job is not to be used and coordinate data is not to be recorded.
19.3 SETTING
5 Select an existing job name with {F1} or {F2}
(Arrow) key, or enter a job name.
Enter/
Select job
name
6 Press {ENT} key.
{ENT}
7 Pressing {F3} (YES) key will delete the job file.
{F3}
Operating procedure Operation Display
1 Select {F1} (TOP FIELD) from the menu.
{MENU}
{F1}
2 Select {F1} (JOB).
{F1}
3 Job selection will be cancelled when {F3} (NO
JOB FILE) is selected.
{F3}
Operating procedure Operation Display
1 Select {F1} (TOP FIELD) from the menu.
{MENU}
{F1}
2 Select {F2} (SETTING).
{F2}
3 To change the setting, select {F2} (EDIT).
 To not change the setting, select {F1} (OK).
{F2}
SELECT JOB TO DEL
[JOB1_ ]
↑ ↓ ALP CLR
SELECT JOB TO DEL
[JOB1_ ]
>OK ? [YES][NO]
4.DELETE JOB FILE
[4]
↓
1.JOB [JOB1 ]
2.SETTING
3.GO TO WORK
[1] [2] [3]
↓
1.OPEN JOB FILE
2.CREATE NEW JOB
3.NO JOB FILE
[1] [2] [3]
↓
<SET!>
1.JOB [ ]
2.SETTING
3.GO TO WORK
[1] [2] [3]
↓
DIST UNITS :FT-10
COORDINATES :XYZ
EDM MODE :FINE
OK EDIT
1.US FEET-10THE
2.US FEET-INCHES
3.METERS
[1] [2] [3]