Topcon ES-65 - Selecting a Coordinate File for Data Collection

7-4
7 DATA COLLECTION
7.1.2 Selecting a Coordinate File for Data Collection
When coordinate data in a coordinate data file are used for occupied point or backsight point, select a
coordinate file from the data collect menu 2/2 beforehand.
Operating procedure Operation Display
1 Press the {F1} (SELECT A FILE) key from DATA
COLLECT menu 2/2.
{F1}
2 Press the {F2} (COORD.DATA) key.
{F2}
3 Select a coordinate file in the same manner as
Section 7.1.1 “Selecting a File for Data Collection”.
DATA COLLECT 2/2
F1:SELECT A FILE
F2:PCODE INPUT
F3:CONFIG. P
↓
SELECT A FILE
F1:MEAS.DATA
F2:COORD.DATA
SELECT A FILE
FN:
INPUT LIST --- ENTER