Topcon ES-65 - Page 195

19-19
19 TOP FIELD MODE
 TAPE
 The calculated value will be displayed for the
coordinate data. Set with {ENT} key.
{ENT}
Operating procedure Operation Display
1 Select {F3} (TAPE).
{F3}
2 In order to acquire coordinate data for reference
"START" point, select an existing coordinate point
with {F1} or {F2} (Arrow) key, or enter a coordinate
point directly.
Enter/
Select PT#
3 Set with {ENT} key.
{ENT}
4 In order to acquire coordinate data for reference
"END" point, select an existing coordinate point
with {F1} or {F2} (Arrow) key, or enter a coordinate
point directly.
Enter/
Select PT#
5 Set with {ENT} key.
{ENT}
PT#: [P03 ]
STORED!
JOB [JOB 1 ]
1.COORDINATES
2.REFLINE
3.TAPE
[1] [2] [3]
START PT#
END PT#
OFFSET
ADD POINT
1.COORDINATES
2.REFLINE
3.TAPE
[1] [2] [3]
ENTER START PT#
PT#: [_ ]
DESC:
↑ ↓ ALP CLR
ENTER START PT#
PT#: [P01_ ]
DESC:
↑ ↓ ALP CLR
ENTER END PT#
PT#: [_ ]
DESC:
↑ ↓ ALP CLR
ENTER END PT#
PT#: [P02_ ]
DESC:
↑ ↓ ALP CLR
ENTER FROM END PT#
L = _ m
LEFT RIGHT CLR