Bluetooth Module Configuration
P/N 7010-0736
2-25
5. Click the Parameters tab (Figure 2-22 on page 2-25). The
Parameters tab sets identifying and security information for your
Bluetooth module. The security section allows you to set data
security and unauthorized access parameters for the Bluetooth
module.
6. Enter up to 14 characters to set a unique name for the Bluetooth
module (Figure 6).
7. To set security parameters (Figure 2-22 on page 2-25), enter and
enable the following, then click Apply:
• Bluetooth PIN – enter up to 16 characters to specify a
personal identification number for the Bluetooth module.
• Encryption – enable to have the Bluetooth module encrypt
wirelessly sent data. To read encrypted data, the user must
have the same PIN used in the device that sent the data.
• Authentication – enable to require a PIN before two
Bluetooth enabled devices (such as, the receiver and a
computer) can establish a communication link. The two
devices must use the same PIN.
Figure 2-22. BTCONF Security Parameters
If you do not need security settings, leave these
parameters disabled.
To Next Page
Loading...
Need help?
General
