P/N 7010-0736
Chapter 4
4-1
GR-3 Receiver Setup
and Survey
After receiver survey configuration, set up each receiver, measure its
height, and begin surveying. The MINTER provides quick access for:
logging data, changing receiver modes, and viewing general data
logging and satellite information during a survey.
Receiver Setup
A typical GPS survey system consists of a Base station set up over a
known point and a Rover receiver set up to be a mobile data collector.
After setting up the Base and Rover receivers, the antenna height
must be measured.
Before collecting data, make sure the Base and Rover receivers
contain a current almanac and current ephemeris data (see “Collecting
Almanacs and Ephemerides” on page 2-26).
Step 1: Set up the Receivers
The Base station must be set up, logging data, and transmitting data
before setting up the Rover receiver.
Set up the Base station and its components.
See “To set up the Base receiver” on page 4-2 for details.
Refer to the GB-500/1000 manual for details on setting up a GB-
500/1000 Base station.
Set up the Rover receiver.
See “To set up the Rover receiver” on page 4-3 for details.
To Next Page
Loading...
Need help?
General
