Loading New Firmware
P/N 7010-0736
5-21
Loading Bluetooth Module Firmware
Bluetooth module firmware is released as a compressed file that you
download and decompress. This file contains the following two files:
• btloader.ldr – the Bluetooth module RAM file
• btmain.ldp – the Bluetooth module Flash file
1. In FLoader, click the Device tab and set the Device Type as
“Receiver”. Then click Get from Device for device information
(Figure 5-23).
Figure 5-23. Get Device Type
2. Click the Program tab and set the Capture Method to “Soft
Break Capture” (recommended) (Figure 5-24 on page 5-22).
3. Browse for and select the Bluetooth module’s RAM file and Flash
file (Figure 5-24 on page 5-22).
You must load both files when loading new
firmware. These files must come from the same
firmware package.