Topcon GR-3 - TX RX LED Blink Pattern on Error Conditions

TX RX LED Blink Pattern on Error Conditions
P/N 7010-0736
6-15
TX RX LED Blink Pattern on
Error Conditions
For internal FH915+ modems: the TX RX LED flashes red
D A fault condition has been detected.
• Check that the radio modem’s antenna is undamaged.
Contact your dealer to replace the antenna.
• Check that the radio modem’s antenna is securely and
properly connected to the antenna connector.
• Move the antenna/receiver away from conducting objects
(such as, large metal objects).
D The cable is damaged.
• Use an undamaged cable.
• Contact your Dealer to replace the cable.
For internal GSM modems: the TX RX LED flashes orange
D The Rover uses the wrong PIN code, or no PIN code was
selected.
1. In TopSURV, click JobConfigSurvey.
2. Click the “...” (continue) button and press Next to
navigate to the Rover Radio configuration screen.
3. Press Configure GSM.
4. Select the PIN of the Base Station and press OK.
D An initialization error has occurred.
• Check that the radio modem’s antenna is undamaged.
Contact your dealer to replace the antenna.
• Check that the radio modem’s antenna is securely and
properly connected to the antenna connector on the
radome.