20
COMPONENT NAMES AND FUNCTIONS
DATA REFERENCE
There are two data reference areas. Data can be displayed in the fixed status in one area by [Set-
tings]. You can select one of the following modes: the mode to display only the one eye data in one
data reference area, and the mode to display the both eyes data there.
(1) Data reference area No. 1
This data display area is used to compare or refer to data.
The same data items as the main data are displayed in a small area.
In the mode to display only the one eye data, two value types of the right eye data are displayed.
(2) Data reference area No. 2
This area works as the data reference area No. 1 and is displayed at the right on the screen.
In the mode to display only the one eye data, two value types of the left eye data are displayed.
(1) (2)
To Next Page
Loading...
