48
Safety Warning and Regulatory Information
X-52/X72 2D Excavator Installation and Calibration Manual P/N: 1022461-01
RF Radiation Hazard Warning
Regulatory Information
IC Statements
This Class (A or B) digital apparatus complies with Canadian ICE-S003.
The term “IC:” before the radio certification number only signifies that Industry Canada technical
specifications were met.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a
type and maximum
(or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (EIRP) is not more than that necessary for successful communication.
This device complies with Industry Canada license exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that necessary for successful
communication.
TPS products should never be used in dangerous environments. Use in rain or snow for a
limited period is permitted.
Tampering with the unit by the operator or non-factory authorized technicians will void the
unit’s warranty:
• Do not attempt to open the unit and modify any of its internal components.
• Do not short circuit.
To ensure compliance with FCC and Industry Canada RF exposure requirements, this device
must be installed in a location where the antennas of the device will have a minimum
distance of at least 20 cm from all persons. Using higher gain antennas and types of
antennas not certified for use with this product is not allowed. The device shall not be
located with another transmitter.
Installez l'appareil en veillant à conserver une distance d'au moins 20 cm entre les éléments
rayonnants et les personnes. Cet avertissement de sécurité est conforme aux limites
d'exposition définies par la norme CNR102 at relative aux fréquences radio.
To Next Page
Loading...
