Need help?Do you have a question about the Topcon X-63 and is the answer not in the manual?
General| Brand | Topcon |
|---|---|
| Model | X-63 |
| Category | Excavators |
| Language | English |
Covers legal aspects including use, copyrights, trademarks, and disclaimers.
Details components and operation of 3D systems.
Details components and operation of 2D systems.
General sensor mounting, TS-1 and TS-i3 sensor specifics.
Describes the procedure for mounting the bucket sensor.
Details the optional mounting of the bucket sensor on the dog-bone.
Describes the optional mounting of a sensor for a tilt bucket.
Provides instructions for mounting the stick sensor.
Details the procedure for mounting the boom sensor.
Covers mounting for secondary boom and body sensors.
Notes, best practices, and taking machine dimensions.
Steps to input sensor details into 3D-MC software.
Procedures to define the orientation for each sensor.
Step-by-step guide for calibrating the body sensor.
Step-by-step guide for calibrating the boom sensor.
Guide for calibrating the secondary boom sensor.
Step-by-step guide for calibrating the stick sensor.
Procedure for calibrating the dog-bone mounted bucket sensor.
Covers bucket edge calibration, CAN termination, and sensor filtering.
Instructions for physically mounting the LS-B10W receiver.
Process to calibrate the LS-B10W receiver with 3D-MC.
Steps for installing drivers and calibrating the compass.
Steps to enable and configure the compass in the system.
Fine-tuning the compass calibration within 3D-MC.
Checks sensor response and system accuracy.
Verifies antenna-to-boom lengths, centerline, and heights.
Performing a test to verify the LS-B10W laser receiver.
Verifies accuracy of boom, stick, and bucket sensors.
Verifies accuracy of the body sensor on a cross slope.
To Next Page
