Topcon X-63 - Full System Test; Machine Element Sensor Accuracy

FullSystemTest
65
X‐63/X ‐63i/X‐62/X‐33/X‐32Installationand Calibra tion Manual P/N:7010‐0697
• • • • • •
Full System Test
Performingafullsystemtestverifiestheaccuracyoftheexcavatorsystemsatvariousmachinepositions.
Testing Machine Element Sensors for Accuracy
Testingthesensorsontheboom,stick,andbucketrequiresthreebucketmeasurementsatthreeboomand
stickextensions.
Usingahub,recordthelocalcoordinateswiththefollowingmachinepositionsfacingNorth,thenrotate180°
andrecordeachpositionagainfacingSouth.Useacopyofthetableon
page68torecordthesepoints.
RecordBucketPositionswithBoomandStickFullyExtended
Ifahubwithaknownpositionisavailable,useittomeasurethepositionsbelow.
Bucket extended
Bucket mid-position
Bucket curled