Topcon X-63 - Method A: Measure Extended Positions at 180; Verifying Main Antenna-To-Boom Length

Verifying Setup

51
X‐63/X‐63i/X‐62/X‐33/X‐32InstallationandCalibrationManual P/N:7010‐0697
Verifying Main Antenna-to-Boom Length
Thedistancefromthemainantennatotheboompivotdeterminesthepositionofthemachinefront/back. 
Errorsinthismeasurementwillhaveadirectcorrespondingpositionerroratthebucket.Useoneofthe
methodsbelowtodeterminetheadjustmentneededtoaccountformeasurementerrors.
Figure71:MainAntenna‐to‐BoomPivot
Method A: Measure extended positions at 180°
Beforeyoubegin,ensurethatallequipmentandmeasurementsareusingthesameunitsofmeasure(i.e.
Meters,SurveyF eet,etc.).
Main