Rev. 000
TX 413 Service Manual
7-55
HYDRAULIC LIFT ASSEMBLY
4. Lubricate and install the lift spool in the right port
of the valve, twist and push gently, so you do not
damage the o-ring (Fig. 385).
Figure 385 DSC-1418
5. Install the spring valve assembly with a hex
wrench and torque to 5 ft-lbs. (6.8 Nm). Lubricate
the spring with synthetic base grease grade
NLGI2 (Fig. 386).
Figure 386 DSC-1419
2. Lubricate and install the spool valve seals in the
top of the valve (Fig. 383).
Note: The thin wall of the seal goes into the valve
body first.
Figure 383 DSC-1416
3. Lubricate the tilt spool. Install the spool in the left
port of the valve; twist and push gently, so you do
not damage the o-ring (Fig. 384).
Figure 384 DSC-1417
To Next Page
Loading...
