Rev. 000
DRIVE SYSTEM
Figure 443 DSC-1724
8-8
TX 413 Service Manual
5. Install the tensioner assembly into the frame (Fig.
443).
4. Install compression spring and the bolt tensioner
with tensioning nut.
Note: Make sure the tensioning nut is contacting
the bolt tensioner (Fig. 442).
Figure 442 DSC-0815
A
C
B
D
A. Tensioning nut C. Tensioning bolt
B. Compression spring D. Tension Arm
Figure 445 DSC-0625
Figure 444 DSC-0624
1. Insert the notched end of the alignment tool into
the drive wheel spacer (Fig. 445).
Alignment Tool – P/N 110-0069 (Fig. 444)
Track Guide Alignment
To Next Page
Loading...
