Rev. 000
TX 413 Service Manual
8-13
DRIVE SYSTEM
Figure 462 DSC-0828
6. Using a drift punch and hammer, tap out the seal
(Fig. 462).
Figure 463 DSC-0829
Installation of Road Wheel Bearing and
Road Wheel Assembly
1. The raised portion of the bearing should be
installed toward the seal side (Fig. 463).
Figure 464 DSC-0830
2. Pressing on the outer race, press bearing in until
it seats against the inner shoulder of the road
wheel (Fig. 464).
Figure 465 DSC-0831
3. Apply grease around the bearing before installing
the seal (Fig. 465).
To Next Page
Loading...
