TX 413 Service Manual
8-9
DRIVE SYSTEM
Rev. 000
Figure 449 DSC-0801
Track Installation
1. Engage the lugs on the track between the
spacers on the drive sprocket (Fig. 449).
Figure 447 DSC-0629
Figure 448 DSC-0631
Figure 446 DSC-0628
2. Secure the end with the pin (Fig. 446).
3. Rotate the tool and move the track guide as
necessary until the tool fi ts into the track guide
channel. Secure the end of the tool with a strap
(Fig. 447).
4. Tighten and torque the 4 track guide mounting
bolts to 75 ft lbs (102 Nm) (Fig. 448).
5. Remove the alignment tool.
To Next Page
Loading...
