Toro Dingo TX 413 - Reassemble Auger Power Head

ATTACHMENTS
10-14 TX 413 Service Manual
Rev. 001
Fig 046 PICT-8712
5. Install the 3 bolts and nuts to secure the pivot plate
to the frame assembly (Fig. 046).
Fig 047 PICT-8717
6. Torquethesixpivotplateboltsto210+ 21 ft-lbs.
(284.7 + 28.5 Nm) (Fig. 047).
1. With the auger housing shaft facing up, use a
bearing driver or press to install bearing. The
bearingisseatedwhenthesurfaceisushwiththe
auger housing (Fig. 048 and Fig. 049).
Fig 048 CLR DSC-0136
Reassemble Auger Power Head
Fig 049 CLR DSC-0138