Toro Dingo TX 413 - Page 41

Rev. 000
ENGINE
12. Install the bolt and nut retaining the hose clamp
for the oil reservoir vent hose and the clamp
holding the fuel shut off valve and tighten (Fig.
059).
Figure 059 DSC-1098
13. Install the two bolts and nuts, left side, holding
the fuel tank bracket to the frame and tighten
(Fig. 060).
Figure 060 DSC-1096
4-12
TX 413 Service Manual
14. Tighten the right side fuel tank bracket nuts and
bolts.
10. Connect the wire terminals for the fuel shut off
valve (Fig. 057).
Figure 057 DSC-1100
11. Connect fuel line and install the fuel line clamp
located at the fuel shut off valve (Fig. 058).
Figure 058 DSC-1099
A - Green wire C - Violet wire
B - Yellow wire D - Pink wire
A
A
B
B
C
C
D
D