Greensmaster 3300/3400Groomer Page 9 -- 16
5. Carefully slide RH drive plate onto grooming reel
shaft taking care to not damage seals in drive plate.
Position drive plate to the support plate on the cutting
unit frame and secure with four (4) button head screws
(item 30). Make sure that drive plate rotates freely after
installation.
6. Installdrivengear(item14)ontogroomingreelshaft:
A. Apply light coating of grease to hub on driven
gear (item 14).
B. Carefullyslidedrivengearontothegroomingreel
shaft taking care to not damage seal in drive plate.
NOTE: To prevent grooming reel shaft from turning
whensecuringdrivengear,usewrench onshaftflats
to hold shaft.
C. Secure gear to shaft with lock nut (item 15).
Torque lock nut from 17 to 21 ft--lb (24 to 28 N--m).
NOTE: Topreventcuttingreelfromturningwheninstal-
ling groomer drive gear (item 1 7), block reel with piece
of wood.
7. Secure groomer drive gear (item 17) to cutting reel
shaft. Torque gear to 125 ft--lb (170 N--m).
8. Install the two (2) idler gears (43T and 47T) to RH
driveplateassembly(Fig. 12).Securegearswithflange
nuts and torque flange nuts 120 in--lb (13.5 N--m).
9. Install extension spring to RH drive plate assembly
(Fig. 11).
10.Insert front roller into LH groomer arm assembly.
11.Makesurethatbushing(item3)isinstalledinRH
drive plate assembly.
12.Apply antiseize lubricant to threads of RH groomer
arm lift r od.
13.Position RH groomer arm assembly to front roller,
RH drive plate and cutting unit frame. Secure groomer
armt o cuttingunit withplow bolt(item31),HOC washer
(item 9) and HOC nut (item 2).
14.SecureRHgroomerarmassemblytodriveplatewith
spring washer (item 4) and lock nut (item 5).
15.Center front roller to cutting unit and tighten cap
screws (item 7) to secure roller.
16.Fillgroomercoverwithapproximatelyfive(5)ounces
(142 grams) of Mobil XHP221 grease (or equivalent).
Install newgasketand then groomer coverassembly to
RH drive plate (see Groomer Cover (Counter Rotating
Groomer Drive) in this section).
17.Check grooming reel height and mower height--of--
cut settings. Adjust as needed.
18.Install cutting unit to the machine.
19.Lubricate groomer bearings (see Groomer Installa-
tion Instruc tions).
NOTE: After greasing groomer bearings, operate
groomerfor30seconds,stopmachineandwipeexcess
grease from groomer shaft and seals.
To Next Page
Loading...
