Toro Multi Pro WM - Inspecting the Hoses; Changing the Suction Filter; Changing the Pressure Filter

InspectingtheHoses
ServiceInterval:Every200hours
Every400hours/Yearly(whichevercomesrst)
Examineeachhoseinthespraysystemforcracks,
leaks,orotherdamage.Atthesametime,inspectthe
connectionsandttingsforsimilardamage.Replace
anyhosesandttingsiftheyaredamaged.
ChangingtheSuctionFilter
ServiceInterval:Every400hours
Note:Determinetheappropriatesuctionltermesh
sizethatyouneedforyourjob;refertoSelectinga
SuctionFilter(page64).
1.Parkthemachineonalevelsurface,engagethe
parkingbrake,shutoffthepump,shutoffthe
engine,andremovethekey.
2.Atthetopofthesprayertank,removethe
retainerthatsecuresthehosettingattached
tothelargehosefromthelterhousing(Figure
101).
g033577
Figure101
1.Suctionhose
2.Retainer
3.Removethehoseandhosettingfromthelter
housing(Figure101).
4.Removetheoldsuctionlterfromthelter
housinginthetank(Figure102).
Note:Discardtheoldlter.
g033578
Figure102
1.Screenvane2.Suctionlter
5.Installthenewsuctionlterintothelterhousing.
Note:Ensurethatthelterisfullyseated.
6.Alignthehoseandhosettingtothelter
housingatthetopofthetank,andsecurethe
ttingandhousingwiththeretainerthatyou
removedinstep2.
ChangingthePressure
Filter
ServiceInterval:Every400hours
Note:Determinetheappropriatepressureltermesh
sizethatyouneedforyourjob;refertoSelectinga
PressureFilter(page65).
1.Parkthemachineonalevelsurface,engagethe
parkingbrake,shutoffthesprayerpump,shut
offtheengine,andremovethekey.
2.Alignadrainpanunderthepressurelter
(Figure103).
72