Toro Multi Pro WM - Installing the Electrical Harnesses for the Sprayer

5.Insertthe2plasticbushingsintothemounting
bracket(Figure18).
InstallingtheControlConsoleto
theMachine
1.Removethehairpinsecuringthepivotpinofthe
controlconsoletothestoragebracketonthe
sprayertank.
2.Installthecontrolconsoleontothecontrol
mountingbracketandsecurethecontrolconsole
withthespring-clippin(Figure19).
Note:Ensurethatthespringclipisrotatedover
thepivotpintopositivelysecurethespring-clip
pin.
g033521
Figure19
1.Spring-clippin3.Controlmountingbracket
2.Pivotpin(controlconsole)
4.Handknob
3.Installthehandknobandtightenittopreventthe
consolefromrotatingduringoperation(Figure
19).
10
InstallingtheElectrical
HarnessesfortheSprayer
Partsneededforthisprocedure:
3J-clips
1
Bolt(1/4x3/4inch)
1
Flangenut(1/4inch)
RoutingtheRearElectrical
HarnessfortheSprayertothe
ControlConsole
1.Install2J-clipsinthecenterconsoleatthe
pointslocatedinFigure20orFigure21using
theexistingscrews.
g002507
Figure20
HD-Seriesmodelswithanmanualtransmission
1.J-clip
3.Control-boxharness
2.Existingscrews
4.Centerconsole
24