Toro ProLine H800 - Page 175

RemovingtheHeightOfCutValve(continued)
g293798
Figure85
1.Quickdisconnectcoupler
5.Bolt9.Hose
2.O-ring
6.Fitting10.Hose
3.Bracket
7.Heightofcutvalve
11.Auxiliarycontrolvalve
4.Hose8.Bolt
12.Steeringcontrolvalve
5.Disconnectthehydraulichosesandtubesfromthettingsintheheightof
controlvalve.Allowthelinestodrainintoasuitablecontainer.Removeand
discardtheO-ringsfromthettings.
6.Installcleancapsorplugsonthehydrauliclinesandttingstoprevent
systemcontamination.
7.Removethe2bolts(item4inFigure84)andwashers(5)thatsecurethe
heightofcutvalvetotheoperatorplatform.
8.Removetheheightofcontrolvalvefromthemachine.
9.Ifnecessary,removethehydraulicttingfromtheheightofcutvalve.Discard
theO-ringsthatwereremoved.
ProLineH800
Page5–107
HydraulicSystem:ServiceandRepairs
19241SLRevB