Toro ProLine H800 - Page 187

RemovingtheHopperLiftCylinder(continued)
CAUTION
Beforeopeningthehydraulicsystem,operateallthehydraulic
controlstoreleasesystempressureandavoidinjuryfromthe
pressurizedhydraulicuid;refertoReleasingPressurefromthe
HydraulicSystem(page5–5).
3.Forassemblypurposes,labelallthehydraulichosesandtubesthatare
connectedtothettingsonthehopperliftcylinder.
g293972
Figure93
1.Bolt
7.O-ring
2.O-ring
8.Bolt
3.Balljoint9.Hose
4.Nut10.Hose
5.Hose11.Hose
6.Hydraulicliftcylinder
12.Auxiliarycontrolvalve
4.Cleanthehydraulichoseendsbeforeyoudisconnectthehosesfromthe
hopperliftcylinder.
5.Disconnectthehydraulichosesfromthehopperliftcylinder.
6.Installcapsorplugsonthedisconnectedhosesandttingstoprevent
contamination.
7.Removethe2snaprings(item4inFigure92)andpin(5)thatsecuresthe
hopperliftcylinder(14)totheLHbracket(6).
8.Removethenut(11)andbolt(13)thatsecuresthehopperliftcylinder(14)
andsafetyhandle(19)tothearm(7).
9.Removetheliftcylinder(14)andsafetyhandle(19)fromthemachine.
10.Ifthehydraulicttingsaretoberemovedfromthehopperliftcylinder,mark
thettingorientationforassemblypurposes.Removethettingsfromthe
hopperliftcylinderanddiscardtheO-ringsfromthettings.
ProLineH800
Page5–119
HydraulicSystem:ServiceandRepairs
19241SLRevB