Toro ProLine H800 - Page 196

RemovingtheChuteCleaningCylinder(continued)
g294113
Figure99
1.Femalequickcoupler5.Hydrauliccylinder
2.O-ring6.O-ring
3.Hose7.Bolt
4.Cuttingdeck
CAUTION
Beforeopeningthehydraulicsystem,operateallthehydraulic
controlstoreleasesystempressureandavoidinjuryfromthe
pressurizedhydraulicuid;refertoReleasingPressurefromthe
HydraulicSystem(page5–5).
4.Disconnectthehydraulichosesfromthettingsinthechutecleaningcylinder
thatistoberemoved.Allowthehosestodrainintoasuitablecontainer.
RemoveanddiscardtheO-ringsfromthettings.
5.Installcleancapsorplugsonthehydraulichosesandttingstoprevent
contamination.
6.Removethesplitpins(item7inFigure98)andpins(5)thatsecuresthe
chutecleaningcylinder(6)tothelevers(4).
7.Removethechutecleaningcylinder(5)fromthecuttingdeck(1).
8.Ifthehydraulicttingsaretoberemovedfromthechutecleaningcylinder,
markthettingorientationforassemblypurposes.Removethettingsfrom
thechutecleaningcylinderanddiscardtheO-ringsfromthettings.
HydraulicSystem:ServiceandRepairs
Page5–128
ProLineH800
19241SLRevB