Toro ProLine H800 - Page 311

DisassemblingtheHopperFrameAssembly
1.Parkthemachineonalevelsurface,lowerthecuttingdeck,shutoffthe
engine,settheparkingbrakeandremovethekeyfromthekeyswitch.
2.Removethehopperassemblyfromthemachine;refertoRemovingthe
HopperAssembly(page9–3).
3.DisassemblethehopperframeassemblyusingtheFigure172andFigure
173asaguide.
4.Ifrequired,disassemblethehopper;refertoDisassemblingtheHopper
(page9–9).
AssemblingtheHopperFrameAssembly
1.Ifdisassembled,assemblethehopper;refertoAssemblingtheHopper
(page9–9).
2.AssemblethehopperframeassemblyusingtheFigure172andFigure173
asaguide.
3.Installthehopperassemblyontothemachineframe;refertoInstallingthe
HopperAssembly(page9–4).
4.Checkandalignthehopperassemblytothechuteseal;refertoOperator’s
Manual.
5.Lubricatethegreasettings;refertoOperator’sManual.
6.Checkforcorrectoperationofthehopperassemblyandadjustthehopper
assemblysensor;refertoOperator’sManual.
ProLineH800
Page9–7
HopperAssembly:ServiceandRepairs
19241SLRevB