Reelmaster 5200-D/5400-DHydraulic System Page 4 - 68
Reel Motor
1
2
3
4
5
6
7
8
9
10
5
14
5
11
12
13
1. Socket head screw
2. Washer
3. Dowel pin
4. Cover
5. Needle bearing
6. Idler gear
7. Drive shaft
8. Ring seal
9. Load plate
10. Body
11. Spacer
12. Shaft seal
13. Retaining ring
14. Dowel pin
Figure 90
17 ft–lb
(23 N–m)
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Disconnect hydraulic lines. Put caps or plugs on fit-
tings and hoses to prevent contamination. Tag hydraulic
lines for proper reassembly.
3. Loosen motor mounting nuts (Fig. 91).
4. Rotate motor clockwise so motor flanges clear studs
and pull motor out.
Installation
1. Place motor into position on mounting studs. Rotate
motor counterclockwise so motor flanges lock to studs.
2. Tighten motor mounting nuts
1. Reel motor 2. Motor mounting nut
Figure 91
1
2
3. Remove caps or plugs from fittings and hoses. Con-
nect hydraulic lines lines to the motor.
To Next Page
Loading...
