Rev. A
Cutting Units
(Model 03527, S/N 210000001 & Up)
(Model 03528, S/N 210000001 & Up)
Reelmaster 5200-D/5400-DPage 8.1 - 2
Specifications
Figure 1
REEL CONSTRUCTION: Fairway reels. All welded. 5
or 8 blades.
HEIGHT OF CUT RANGE:
5 Blade - 5/8” to 1” (13-25 mm)
8 Blade - 1/4” to 5/8” (6-16 mm)
Note: Heavy duty bedknife Part No. 100-3350 available
for height-of-cuts over 1/2” (13 mm).
REEL DIAMETER: 5 in. (127 mm)
REEL BEARINGS: Taper roller bearings
POWER: Hydraulic motor splined to reel shaft. Reel mo-
tors feature quick disconnect for removal or installation
onto cutting unit.
BEDKNIFE AND BEDBAR ADJUSTMENT: Opposing
fine thread screws
HEIGHT–OF–CUT & ROLLER ADJUSTMENT:
Front: 3 fixed positions for setting cutting unit attitude.
Optional Adjustable Front Height Of Cut kit, part no.
104–8205, allows for variable adjustment to cutting unit
attitude with adjustable height of cut rods, within the
height of cut range of 1/4” to 1 3/8”.
Rear: Screw adjustable with bolt clamp lock used for
setting height of cut.
Selected Clip Control: The Reelmaster 5200/5400 is
equipped with manually adjustable reel speeds (275
rpm to 2000 rpm) which control selected clip.
Rollers: Front roller is a 3” (76 mm) diameter cast
Wiehle roller. Rear roller is a 2.5” (64 mm) diameter
steel full roller. Both rollers use heavy duty ball bearings
with two conventional single lip seals and a Toro laby-
rinth seal to provide four sealing surfaces to protect the
bearings.
OPTIONS & KITS:
Basket Kit (3 baskets) Model 03532
Rear Roller Brush Kit Model 03533
Wiehle Roller Scraper Part No. 104-3380-03
Rear Roller Scraper Kit Part No. 104-3395
Shoulder Wiehle Roller Part No. 104-3369
Shoulder Wiehle Scraper Part No. 104-8208-03
Comb Kit Part No. 104-3385
Adjustable Front H.O.C. kit Part No. 104-8205
To Next Page
Loading...
