Rev. A
Reelmaster 5200-D/5400-DPage 8 - 12Cutting Units
(Model 03506, S/N 80001 - 209999999)
(Model 03509, S/N 80001 - 209999999)
Adjust Cutoff Bar
Adjust top bar to make sure clippings are cleanly dis-
charged from reel area:
NOTE: Bar should be parallel to reel for optimum per-
formance and should be adjusted whenever shield
height is adjusted or whenever reel is sharpened on a
reel grinder.
1. Loosen screws securing top bar. Insert 0.060 inch
(1.52 mm) feeler gauge between the top of the reel and
bar; tighten screws. Make sure bar and reel are an equal
distance apart across the entire reel.
2. Do adjustment on remaining cutting units.
1. Cutoff bar 2. Mounting screw
Figure 15
1
2
Adjust Lock-up Roller
Adjust lock-up rollers so they contact the lock-up lever
on each rear lift arm and support the cutting units when
fully raised. The cutting units should have approximately
3/8 to 5/8 inch (9.5 to 15.9 mm) vertical travel when mea-
sured at the rear roller.
1. Lock-up roller 2. Lock-up lever
Figure 16
1
2
To Next Page
Loading...
