EasyManuals Logo

Toro Reelmaster 5200-D Service Manual

Toro Reelmaster 5200-D
296 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #243 background imageLoading...
Page #243 background image
Cutting Units
Model 03527 & 03528
Rev. A
Reelmaster 5200-D/5400-D Page 8.1 - 13 Cutting Units
(Model 03527, S/N 210000001 & Up)
(Model 03528, S/N 210000001 & Up)
Front Grass Shield Adjustment
Adjust front grass shield for desired grass clippings dis-
persion.
1. Position cutting unit on a flat level surface.
2. Loosen capscrews and nuts securing shield to each
side plate. Move shield to desired angle and tighten fas-
teners (Fig. 20).
Figure 20
1
2
1. Front grass shield 3. Capscrew & nut
Rear Shield Adjustment
Under most conditions, best dispersion is attained when
rear shield is closed (front discharge). When conditions
are heavy or wet, rear shield may be opened.
1. To open rear shield, loosen flange head capscrew
securing shield to right side plate, rotate shield to open
position and tighten screw (Fig. 21).
Figure 21
1
1. Rear grass shield mounting screw
Cut-Off Bar Adjustment
The Cut–Off bar is designed to keep the gap between
the reel and the Cut–Off minimal to insure grass clip-
pings discharge cleanly from reel area.
Note: The gap between the Cut–Off bar and reel will
increase as: 1) the reel wears, 2) reel is sharpened by
grinding, or 3) if the front grass shield is adjusted.
1. Loosen screws securing Cut–Off bar (Fig. 22). Insert
0.060” (2 mm) feeler gauge between top of reel and
Cut–Off bar.
Figure 22
1
2
1. Cut-off bar 3. Screw (4)

Table of Contents

Other manuals for Toro Reelmaster 5200-D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toro Reelmaster 5200-D and is the answer not in the manual?

Toro Reelmaster 5200-D Specifications

General IconGeneral
BrandToro
ModelReelmaster 5200-D
CategoryLawn Mower
LanguageEnglish

Related product manuals