Reelmaster 5200-D/5400-DHydraulic System Page 4 - 70
2. Apply grease or petroleum jelly to ring seal and install
on body.
3. Apply hydraulic oil to inside of cover and assemble
the cover to the body, making sure none of the partsbe-
come displaced. Insert the cap screws and washers and
hand tighten.
4. Before tightening the cap screws, rotate the drive
shaft in the direction of normal rotation (counterclock-
wise) to check for binding. You may not be able to rotate
the drive shaft by hand. Protect the shaft if using a pliers.
5. Tighten the cap screws evenly in a crossing pattern
to a torque of 17 ft-lb (23 N-m).
6. Carefully install a new spacer, shaft seal and snap
ring (see Shaft Seal Installation).
To Next Page
Loading...
