Toro reelmaster 5410 series - Page 325

DisassemblingtheCuttingReelMotor(continued)
IMPORTANT
Beforeremovingthewearplates,notethepositionoftheopenand
closedsideofthewearplates.Alsoidentifythewearplates(front
andrear)withamarkerforproperassembly.
IMPORTANT
Marktherelativepositionsofthegearteethandwearplatessothat
youcanassembletheminthesameposition.Donottouchthegear
surfacesasresidueonhandsmaybecorrosivetogearnish.
9.Carefullyremovetherearwearplate,idlergear,drivegear,andfrontwear
platefromthefrontange.
10.Removeanddiscardtheback-upgasketsandpressuresealsfromthewear
plates.
11.Turnthefrontangeover,withthesealsideup.
IMPORTANT
Ensurethatyoudonotdamagethefrontangecounterborewhen
removingthesealsfromthefrontange.
g216671
Figure175
1.Dustseal3.Flangewasher
2.Retainingring
4.Shaftseal
12.Carefullyremovethedustseal,retainingring,angewasher,andshaftseal
fromthefrontange.Notetheorientationofseallipsduringremoval(Figure
175).Discardtheseals.
13.OnReelmaster5510and5610seriesmotor,removethecross-overrelief
valvesfromtherearangeifnecessary.
InspectingtheCuttingReelMotor
1.Removeanynicksandburrsfromallthepartswithemerycloth.
Reelmaster
®
5410/5510/5610Series
Page6–207
HydraulicSystem:ServiceandRepairs
15216SLRevC