Toshiba E-STUDIO2006 - Page 65

3
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
OUTLINE OF THE MACHINE
3 - 23
[ 3 ] Drawer feed copying (1st drawer paper feeding)
1. Press the [START] button
 “READY”  “COPYING”
 CIS LED ON
 Scan motor ON  CIS unit move forward
 Polygonal motor rotates
 Main motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
2. Drawer paper feeding
Main charger, developer bias and discharge LED ON. Fans are rotated in high speed. Drawer
feed clutch ON.
- Paper feed roller start to rotate.
Paper reaches the registration roller
- The registration sensor is turned ON and aligning is performed.
Drawer feed clutch OFF
3. After the scanning operation:
Registration roller clutch ON after a certain period of time  paper is transported to the transfer
area
Copy counter operates
4. After the registration roller clutch is turned ON:
Transfer charger ON after a certain period of time
Copy counter operates
5. Completion of scanning
Scan motor OFF
CIS LED OFF
Registration roller clutch OFF (after the trailing edge of the paper passed the registration roller)
Ready state
6. Paper exit
Exit sensor detects the trailing edge of the paper
Main charger, developer bias and discharge LED OFF
Polygonal motor, main motor OFF
Drum, fuser unit and developer unit stop
Fans return to the ready rotation
“READY” is displayed and the equipment enters the ready state